# Before you can run the adaptation layer and router, you must
# configure the address your router will advertise to the subnet, and
# which network interface to proxy neighbor advertisements on.  
#

# set the debug level of the output
# choices are DEBUG, INFO, WARN, ERROR, and FATAL
# log DEBUG

# set the address of the router's 802.15.4 interface.  The interface
# ID must be a 16-bit short identifier.
addr fec0::64

# the router can proxy neighbor IPv6 neighbor discovery on another
# interface so that other machines on the subnet can discover hosts
# routing through this router.  This specifies which interface to proxy
# the NDP on.
proxy lo #eth1

# which 802.15.4 channel to operate on.  valid choices are 11-26.
channel 15