You can install Blink on a mote via the following command:
make <platform> threads install
-Valid platforms are currently: tmote, telosb, iris, mica2, and micaz
+Valid platforms are currently: tmote, telosb, iris, mica2, micaz, and epic
Upon a successful burn, you should see LED0 flashing with a period of every
200ms, and LED1 and LED2 flashing in unison with a period of 1000ms.
You can install Blink_DynamicThread on a mote via the following command:
make <platform> threads install
-Valid platforms are currently: tmote, telosb, iris, mica2, and micaz
+Valid platforms are currently: tmote, telosb, iris, mica2, micaz, and epic
Upon a successful burn, you should see LED0 flashing with a period of every
200ms, and LED1 and LED2 flashing in unison with a period of 1000ms.
make <platform> threads install.0
make <platform> threads install.1
-Valid platforms are currently: tmote, telosb, iris, mica2, and micaz
+Valid platforms are currently: tmote, telosb, iris, mica2, micaz, and epic
Three different threads run, and each contains an infinite loop that first sends
a message and then waits to receive a message before returning to the top of the
make <platform> threads install.0
make <platform> threads install.1
-Valid platforms are currently: tmote, telosb, iris, mica2, and micaz
+Valid platforms are currently: tmote, telosb, iris, mica2, micaz, and epic
The application burned with NODE_ID 0 will be programmed as a receiver and will
wait for messages from the sender programmed with NODE_ID 1. In the case of the
You can install TestCollection on a mote via the following command:
make <platform> threads install
-Valid platforms are currently: tmote, telosb, mica2, micaz and iris
+Valid platforms are currently: tmote, telosb, mica2, micaz, iris, and epic
At least two motes must be used by this application, with one of them installed
as a base station. Base station motes can be created by installing them with
You can install TestJoin on a mote via the following command:
make <platform> threads install
-Valid platforms are currently: tmote, telosb, iris, mica2, and micaz
+Valid platforms are currently: tmote, telosb, iris, mica2, micaz, and epic
Upon a successful burn, you should first see LED0 flash twice with a period of
1s and LED1 flash 4 times with a period of 1s. After these are done,
You can install TestPrintf on a mote via the following command:
make <platform> threads install
-Valid platforms are currently: tmote, telosb, iris, mica2, and micaz
+Valid platforms are currently: tmote, telosb, iris, mica2, micaz, and epic
Once burned on a mote, the java based PrintfClient must be ran to verify
proper operation of the application. For example, to connect PrintfClient
You can install TestSineSensor on a mote via the following command:
make <platform> threads install
-Valid platforms are currently: tmote, telosb, iris, mica2, and micaz
+Valid platforms are currently: tmote, telosb, iris, mica2, micaz, and epic
This application simply takes sensor readings in an infinite loop from the
SineSensor and forwards them over the serial interface. Upon successful