--- /dev/null
+
+/*
+ * Copyright (c) 2005-2006 Rincon Research Corporation
+ * All rights reserved.
+ *
+ * Redistribution and use in source and binary forms, with or without
+ * modification, are permitted provided that the following conditions
+ * are met:
+ * - Redistributions of source code must retain the above copyright
+ * notice, this list of conditions and the following disclaimer.
+ * - Redistributions in binary form must reproduce the above copyright
+ * notice, this list of conditions and the following disclaimer in the
+ * documentation and/or other materials provided with the
+ * distribution.
+ * - Neither the name of the Rincon Research Corporation nor the names of
+ * its contributors may be used to endorse or promote products derived
+ * from this software without specific prior written permission.
+ *
+ * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
+ * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
+ * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
+ * FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE
+ * RINCON RESEARCH OR ITS CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT,
+ * INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES
+ * (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR
+ * SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
+ * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT,
+ * STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
+ * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED
+ * OF THE POSSIBILITY OF SUCH DAMAGE
+ */
+
+/**
+ * Test the effectiveness of the PacketLink layer
+ *
+ * Transmitter == 1, 2, 3, 4, or 5 (up to MAX_TRANSMITTERS)
+ * Receiver == 0
+ *
+ * Expect:
+ * Transmitter (ID not 0) -
+ * led1 toggling on every successfully delivered message
+ * led0 toggling on every unsuccessfully delivered message (and stay on
+ * until the next dropped packet)
+ *
+ * Receiver (ID 0) -
+ * Leds represent the binary count of sets of messages that were dropped
+ * or duplicated.
+ *
+ * Ideally, if the transmitter and receiver are in range of each other,
+ * the receiver's LEDs should never turn on. You can pull the receiver
+ * out of range for up to two seconds before the transmission will fail.
+ * If you aren't convinced the receiver is doing anything because its
+ * leds aren't flashing, just turn it off and watch the transmitter's
+ * reaction.
+ *
+ * @author David Moss
+ */
+
+#include "TestPacketLink.h"
+
+configuration TestPacketLinkC {
+}
+
+implementation {
+
+ components TestPacketLinkP,
+ MainC,
+ ActiveMessageC,
+ CC2420ActiveMessageC,
+ new AMSenderC(AM_PACKETLINKMSG),
+ new AMReceiverC(AM_PACKETLINKMSG),
+ SerialActiveMessageC,
+ new SerialAMSenderC(AM_PACKETLINKMSG),
+ new TimerMilliC(),
+ LedsC;
+
+ TestPacketLinkP.Boot -> MainC;
+ TestPacketLinkP.RadioSplitControl -> ActiveMessageC;
+ TestPacketLinkP.SerialSplitControl -> SerialActiveMessageC;
+ TestPacketLinkP.SerialAMSend -> SerialAMSenderC;
+ TestPacketLinkP.PacketLink -> CC2420ActiveMessageC;
+ TestPacketLinkP.AMPacket -> ActiveMessageC;
+ TestPacketLinkP.AMSend -> AMSenderC;
+ TestPacketLinkP.Receive -> AMReceiverC;
+ TestPacketLinkP.Timer -> TimerMilliC;
+ TestPacketLinkP.Leds -> LedsC;
+
+}
+