// $Id$
-/* tab:4
+/*
* "Copyright (c) 2004-5 The Regents of the University of California.
* All rights reserved.
*
* cannot satisfy; in this case, it will signal sendDone with an
* appropriate error code.
*
- * @param msg the packet to send
+ * @param 'message_t* ONE msg' the packet to send
* @param len the length of the packet payload
* @return SUCCESS if the request was accepted and will issue
* a sendDone event, EBUSY if the component cannot accept
* handling much of the logic; in this case, a component
* should be conservative and return an appropriate error code.
*
- * @param msg the packet whose transmission should be cancelled
+ * @param 'message_t* ONE msg' the packet whose transmission should be cancelled
* @return SUCCESS if the packet was successfully cancelled, FAIL
* otherwise
*/
* is the sent buffer, and <tt>error</tt> indicates whether the
* send was succesful, and if not, the cause of the failure.
*
- * @param msg the message which was requested to send
+ * @param 'message_t* ONE msg' the message which was requested to send
* @param error SUCCESS if it was transmitted successfully, FAIL if
* it was not, ECANCEL if it was cancelled via <tt>cancel</tt>
*/
* behaves identicallt to <tt>Packet.getPayload</tt> and is
* included in this interface as a convenience.
*
- * @param msg the packet
- * @return a pointer to the packet's payload
+ * @param 'message_t* ONE msg' the packet
+ * @return 'void* COUNT_NOK(len)' a pointer to the packet's payload
*/
command void* getPayload(message_t* msg, uint8_t len);