then with an id of 210 to check that the data is correct. Or install
with an id of 10 to do a combined write+read test.
-A successful test will blink the yellow led a few times, then turn on
-the green led. A failed test will turn on the red led. A serial message
-whose last byte is 0x80 for success and all other values indicate
-failure is also sent at the end of the test.
+A successful test will blink LED 2 a few times, then turn on LED 1. A
+failed test will turn on LED 0. A serial message whose last byte is 0x80
+for success and all other values indicate failure is also sent at the
+end of the test.
Tools: