components
//Change components below as desired
Tda5250RadioC as Radio, //The actual Tda5250 radio over which data is receives/transmitted
+#ifdef PHY_MANCHESTER
+ UartManchPhyC as UartPhy,
+#else
Uart4b6bPhyC as UartPhy, //The UartPhy turns Bits into Bytes
+#endif
PacketSerializerP as PacketSerializer, //The PacketSerializer turns Bytes into Packets
- // RedMacC as Mac, //The MAC protocol to use
+#ifdef MAC_REDMAC
+ RedMacC as Mac, //The MAC protocol to use
+#elif defined(MAC_SPECKMACD)
+ SpeckMacDC as Mac, //The MAC protocol to use
+#else
CsmaMacC as Mac, //The MAC protocol to use
-
- LinkLayerC as Llc; //The Link Layer Control module to use
+#endif
+ LinkLayerC as Llc; //The Link Layer Control module to use
//Don't change wirings below this point, just change which components
- //They are compposed of in the list above
+ //They are compposed of in the list above
- components MainC;
- MainC.SoftwareInit -> PacketSerializer;
-
SplitControl = Llc;
Llc.MacSplitControl -> Mac.SplitControl;
Llc.RadioSplitControl -> Radio.SplitControl;
UartPhy.RadioByteComm -> Radio.RadioByteComm;
+#ifndef RADIO_UART_VCO
components SmclkManagerC;
+#endif
+
+#ifdef PACKETSERIALIZER_DEBUG
+ components new SerialDebugC() as SD;
+ PacketSerializer.SerialDebug -> SD;
+#endif
+
}