Clean up bit definitions in port configuration.

diff --git a/src/examples/cpfactory.c b/src/examples/cpfactory.c
index be9594b31d3d0ef3009d4df49a4ff702b248723b..a3fc0b4637208ac18d7a564da1e1780ae07414e5 100644 (file)
--- a/src/examples/cpfactory.c
+++ b/src/examples/cpfactory.c
@@ -89,10 +89,10 @@ int main(int argc, char* argv[])
     /* Mode and latch bit to pin assignments. See AN223 from SiLabs:
      * https://www.silabs.com/Support Documents/TechnicalDocs/an223.pdf
      *
-     *  15 - /SUSPEND
-     *  14 - SUSPEND (maybe)
-     *  13 - unused (or SUSPEND)
-     *  12 - unused (or SUSPEND)
+     *  15 - /SUSPEND  Can't configure latch
+     *  14 - SUSPEND   Can't configure latch
+     *  13 - unused
+     *  12 - unused
      *  11 - GPIO_3
      *  10 - GPIO_2
      *   9 - GPIO_1
@@ -122,14 +122,14 @@ int main(int argc, char* argv[])
      *       driver sinks current to ground.
      *
      * Enhanced function bits:
-     *   7 - maybe dynamic suspend for UART or GPIO
-     *   6 - maybe dynamic suspend for UART or GPIO
-     *   5 - maybe dynamic suspend for UART or GPIO
+     *   7 - GPIO dynamic suspend, for 4 GPIO signals
+     *   6 - Serial dynamic suspend, for 8 UART/Modem signals
+     *   5 - unused, leave zero
      *   4 - Enable weak pull-ups
-     *   3 - unused
+     *   3 - unused, leave zero
      *   2 - /RS485_TX on GPIO_2
-     *   1 - /RXACT on GPIO_1
-     *   0 - /TXACT on GPIO_0
+     *   1 - /RXLED on GPIO_1
+     *   0 - /TXLED on GPIO_0
      */
     config.reset.mode = 0xf054;
     config.suspend.mode = 0xf054;